|
Related Topics:
| rivets - Has anyone ever used closed end blind pop rivets for rivet on aluminum boats. They are suppossed to be water tight and can be installed with a pop rivet type gun.
Cracked Ribs & loose Rivets in my Jon boat...please advise - I pulled the rotten wood decking out of my jon boat, which I recently and noticed that the 3 center supports are chacked through the middle. Someone put 2 pieces of aluminum channel across the cracked areas and attached them with rivits. They..
four-barrel setting - Hello group, hopefully a simple question: For a carb, at what RPM setting should the 3&4 barrels be set to open at? For example should they open when to climb onto plane, and then once on plane, throttle back and plane with only..
Outboard pitch setting - I just installed a LS Merc 50 on a 14' runabout. There are six potential positions for motor pitch. I'm sure trial and error will determine the final setting, but I'd like to the concept of what different settings will..
trim tab vane setting - '77 Johnson 115hp. How do I set the trim tab vane on the lower unit? It's easy to loosen, set, and tighten. However, what I'm asking is where to set it, how to know if it's the right setting, etc. I seem to remember it's some kind of trial and..
|
|
|
FAQ
Search
Profile
Private Messages
Log in
