1978 mercury 402 problem

Hi,

the problem is, the motor won't start with throttle in idle
position with or without choke engaged.
If i move the lever further, the motor starts without problems
but logically with higher RPM.
Now i slowly pull the lever back down to idle position
and the motor stops.
I've checked the static timing settings (lever positions around carb),
static spark advance lever position and all seems ok.
I've checked too the dynamic timing with a strobe lamp and
it seem's ok too.
I've changed the diaphragma in the fuel pump and the carb needle valve,
but without success.
Then i've carefully and thorouhgly cleaned the carb, but without success
too
Any thoughts????

Regards
Thomas Altmeyer


Germany

"Thomas Altmeyer" <taltmeyer.DeleteThis@aol.com> wrote in message news:3F5B66FF.FE4EEF42@aol.com...
: Hi,
:
: the problem is, the motor won't start with throttle in idle
: position with or without choke engaged.
: If i move the lever further, the motor starts without problems
: but logically with higher RPM.
: Now i slowly pull the lever back down to idle position
: and the motor stops.
: I've checked the static timing settings (lever positions around carb),
: static spark advance lever position and all seems ok.
: I've checked too the dynamic timing with a strobe lamp and
: it seem's ok too.
: I've changed the diaphragma in the fuel pump and the carb needle valve,
: but without success.
: Then i've carefully and thorouhgly cleaned the carb, but without success
: too
: Any thoughts????
:
: Regards
: Thomas Altmeyer
:
:
: Germany

I know nothing about your particularly system - so you might want
to stop reading right here...
Sounds like you've done all the mechanical checks - so now look
at the electrics:
Is the throttle rubbing through the coil wire?
Is there a neutral cutout switch between the key and the starter and
is it adjusted correctly? Is it broken/falling off/shorting somewhere?

At least, that's where I'd go now.
Dave