Mike wrote:
> My old '71 Evinrude 50 doesn't have a tell tale, however, I read an
> article on the net that stated hooking up a tell tale is relatively
> simple.
> The article said there is a bolt on the cylinder head that leads
> directly to a water passage, that you remove this bolt and install a
> fitting to connect your tell tale hose. But he doesn't say where the
> bolt is located.
> I've searched the net trying to find where this bolt is located with
> no luck.
> I'm beginning to think this bolt is a figment of someones imagination.
> Any help will be greatly appreciated.
It won't work... ther is no such bolt on those loopers.
Get used to the sound of the exhaust at start-up. It is usually a
little louder until the exhaust mixes with water and is silenced at the
exhaust reliefs at the rear of the leg below the powerhead. Water will
run out of these ports nearly all the time at different rates and at
different speeds. Just be aware of regular flow here... it will serve
as your "tell-tale".
Rob<!-- ~MESSAGE_AFTER~ -->
>> Stay informed about: 1971 Evinrude 50 hp tell tale 
FAQ
Profile
Private Messages
Log in
